RECEIVER
	Specification
	As standard, the Landmark Receiver is configured as follows. ( Note that this is only the minimum specification - greater I/O capacity can be achieved through the expansion options detailed further below. ) - 2 analogue outputs Generates 4-20mA or 0-5V signals - 16 volt free digital inputs Relay or open-collector outputs. - 4 pulse output signals 2 x 32-bit counters - relay or o/c outputs. - MPT1329 radio receiver Allows transmission distances of up to 10km licence-free. - Integral 110/240V power supply.
	Operation
	The Receiver is constantly monitoring the required radio frequency for transmitted data. Any valid received data will be output in its original form, and via the RS232 serial output. Only valid data is output - if data fails the comprehensive security checks, it is ignored and the previous state is maintained. Alarms can be generated at the Receiver to show transmitter status for fail-safe purposes.
	Expansion
	The configuration shown above is the minimum for a standard Landmark Receiver. Expansion modules may be added to allow a single receiver to accommodate in excess of 128 digital and 16 analogue outputs. Details of all expansion options can be found in our on-line catalogue.
	Technical Data
	Further information may be gained by downloading the Landmark Receiver Manual or by accessing the Troubleshooting section of this website.